Notes on automotive high pressure fuel pump

    -If combined with high-pressure pumps and high-pressure water guns to form an automated earth-moving generator set for hydroelectric machinery, it can be used for site levelling, dredging and excavation of river banks and fish ponds and other small and medium-sized water and hydroelectric projects.

    -Drainage pipes and liquids with soil, air defence projects in large cities, underground waterproofing projects.

    -Fish farming as damp pond clearing, pond oxygenation, etc.

    Application notes.

    -Application switch power supply must be three-phase four-wire system, if there is no wire connector, pneumatic oil pump must be modified to prevent walking electricity.

    -When working, it must be equipped with a power circuit breaker and even switch in close proximity to the motor to prevent burning of the motor when the centrifugal impeller is stuck with dirt.

    -The motor can be used without installing any basic equipment, but it is only necessary to lay it on its side to prevent accidents.

    -Check the motor's rotating position after starting, do not turn it over for more than one minute.

    -When the liquid to be sucked and sent with more weeds and other dirt, eliminate as much as possible beforehand, and can be used to add wire baskets and other ways to avoid dirt sucked into the pump to cause the centrifugal impeller to break down and get stuck.

    -The pump casing should be given a short period of time to absorb moisture after sucking mud and other turbidity, so that the small high temperature oil pump can be easily cleaned inside the pump casing and pipeline.

    -When working outdoors, the motor should be equipped with a protective cover to prevent precipitation from penetrating the motor.

    -At the bottom of the lake, the pool should be hung on a tripod to absorb the mud, and can be shelved in a floating barrel or boat to move the work.